White Ensign Models 1/32 Carrier Deck Tie-Downs Photoetch Enhancement Parts

$25.41

White Ensign Models 1/32 Carrier Deck Tie-Downs Photoetch Enhancement Parts

SKU: 3201 Categories: , Tag:

Description

White Ensign Models 1/32 Carrier Deck Tie-Downs Photoetch Enhancement Parts

White Ensign Models 1/32 Carrier Deck Tie-Downs Photoetch Enhancement Parts

The White Ensign models Photoetch add-ons makes your model ship museum quality.

General instructions:

  • Do not remove the etched parts from the fret until you are ready to use them.
  • Before assembly, soak the etched parts in a suitable solvent, such as white spirit, to de-grease the surfaces for painting.
  •  Cyanoacrylate adhesive (super glue) or contact adhesive such as Elmers white glue may be used. These can be applied with a pin or piece of stretched sprue.
  •  When removing parts from the fret, place the fret on a hard surface, such as a smooth ceramic tile, in order to prevent parts bending whilst cutting through the holding
    tabs. We suggest using a #11 type of modelling knife blade for this purpose.
  •  When shaping or bending a part, a straight-edged blade such as a chisel blade #17 or # 18 will give a good sharp corner, or alternatively a small pair of smooth-jawed
    pliers may be used.
  •  If a part is bent incorrectly, lay it on a hard flat surface and roll it flat with a cylindrical object such as a modelling knife handle.
  •  We suggest that where stock lengths of rails are supplied, these are pre-measured before cutting, where practical, using a pair of compass dividers and then tacked
    to the deck edge every third or fourth stanchion with a small drop of glue. When a section is complete, run a thin line of glue along the inside edge to attach it firmly to
    the deck.

Accordingly, we suggest you purchase our Photoetch Bender Tools for easy assembly.

Additional information

Weight 0.25 lbs
Dimensions 12 × 6 × 6 in

You may also like…