White Ensign Models 1/350 U.S. Quad Guns Photoetch Enhancement Parts

$6.50

White Ensign Models 1/350 U.S. Quad Guns Photoetch Enhancement Parts

Description

White Ensign Models 1/350 U.S. Quad Guns Photoetch Enhancement Parts

White Ensign Models 1/350 U.S. Quad Guns Photoetch Enhancement Parts

It portrays greater detail than can be incorporated in any injection molded kit.

This is similar to Gold Medal Models 350-10 GUN DETAILS but White Ensign Models (WEM) includes more details for a more realistic model.

This set contains:

  • 6 multi-part mounts to represent the early WWII light AA mounting

General instructions:

  • Do not remove the etched parts from the fret until you are ready to use them.
  • Before assembly, soak the etched parts in a suitable solvent, such as white spirit, to de-grease the surfaces for painting.
  • Cyanoacrylate adhesive (super glue) or contact adhesive such as Elmers white glue may be used. These can be applied with a pin or piece of stretched sprue.
  • When removing parts from the fret, place the fret on a hard surface, such as a smooth ceramic tile, in order to prevent parts bending whilst cutting through the holding
    tabs. We suggest using a #11 type of modelling knife blade for this purpose.
  • When shaping or bending a part, a straight-edged blade such as a chisel blade #17 or # 18 will give a good sharp corner, or alternatively a small pair of smooth-jawed
    pliers may be used.
  • If a part is bent incorrectly, lay it on a hard flat surface and roll it flat with a cylindrical object such as a modelling knife handle.
  • We suggest that where stock lengths of rails are supplied, these are pre-measured before cutting, where practical, using a pair of compass dividers and then tacked
    to the deck edge every third or fourth stanchion with a small drop of glue.

Accordingly, we suggest you purchase our Photoetch Bender Tools for easy assembly.

Additional information

Weight 0.25 lbs
Dimensions 12 × 6 × 3 in

You may also like…