Description
White Ensign Models 1/350 USS Nimitz Air Wing Photoetch Enhancement Parts
White Ensign Models 1/350 USS Nimitz Air Wing Photoetch Enhancement Parts
This set contains:
- Aircraft Cockpit Interior
- Sikorsky SH3 Sea King
- NA RA5C Vigilante
- McDD F4J Phantom II
- LTV A7 Corsair II
- Grumman A6 Intruder
- Lockheed S3A Viking
- Douglas A3 Sky warrior
- Aircraft Exterior Details
- Douglas A3 Sky warrior
- Lockheed S3A Viking
- Grumman E2 Hawkeye
- LTV A7 Corsair II
- NA RA5C Vigilante
- Sikorsky SH3 Sea King
- E2C Hawkeye Propellers
- McDD F4J Phantom II
- Grumman A6 Intruder)
- Aircraft Hangar Handler
- Missile Trolley Rack
- Aircraft Jacks
- Start Cart Hoses
- F4 Phantom Entry Ladders
- Aircraft Tow Bars
- Liquid Replenishment Trolley
- Flat Bed Trolley
- Flight Deck Crash Barrier
- Universal Towing Arm
General Instructions for working with Photoetched Metal
- Do not remove the etched parts from the fret until you are ready to use them.
- Before assembly, soak the etched parts in a suitable solvent, such as white spirit, to de-grease the surfaces for painting. It is recommended that the entire fret be primed
with an acrylic automotive primer, such as Halfords Grey Primer before assembling any of the parts. - Cyanoacrylate adhesive (super glue) or contact adhesive such as a white PVA glue may be used. These can be applied with a pin or piece of stretched sprue.
- When removing parts from the fret, place the fret on a hard surface, such as a smooth ceramic tile, in order to prevent parts bending whilst cutting through the holding
tabs. We suggest t using a No.10 rounded type of modelling knife blade for this purpose. - When shaping or bending a part, a straight edged blade such as a chisel blade will give a good sharp corner.
Accordingly, we suggest you purchase our Photoetch Bender Tools for easy assembly.
