Sherline 55 Deg. Straight Carbide Insert Holder, 3/8 inch Shank 2262


Sherline 55 Deg. Straight Carbide Insert Holder, 3/8 inch Shank 2262
SKU: sher-2262 Category: Tag:


Sherline 55 Deg. Straight Carbide Insert Holder, 3/8 inch Shank 2262

55 Deg. Straight Carbide Insert Holder

This holder is not offset to either side, and it comes with a 55° carbide insert, hold-down screw and special Torx key. The 3/8″ square shank is held in a 3/8″ tool post. The straight tip tool can be used as a general turning tool, cutting either right or left. The tip of the cutting tool is .375″ from the bottom of the holder, which is the industry standard. The holders are made from case hardened steel with a black oxide finish.

Though relatively expensive, if a cutting edge becomes dull or chipped, the insert can be removed and rotated 180° to expose two new cutting surfaces, providing, in effect, two tools for the price of one.

In addition to the P/N 2258 RH and LH 55° insert holder set, Sherline now manufactures a straight 3/8” shank holder for the popular 55° negative rake carbide inserts. This general-purpose tool can be used in either direction equally well. It takes the standard P/N 7605 carbide insert that has a .015” nose radius, providing a smooth finish without overloading the cutting capacity of small machine tools. The 3/8” shank holder is made from case hardened steel and has a durable black oxide finish. Included is one 55° insert, a Torx hold-down screw and a Torx key.


TOOL POSTS: Sherline 3/8” shank tools can be held with the standard height P/N 7600 tool post or the 3/8” riser tool post-P/N 1289. For those who prefer using the P/N 2250 quick change tool post set, there is now a special quick-change 3/8” shank holder P/N 2282.

About the Cutter Inserts

The primary method of cutting metal on miniature machine tools is usually with high-speed steel tools as they are inexpensive, easily resharpened and can be ground into “form” tools for special jobs. However, inserted tip tools can be lifesavers for some jobs. This is why they find a lot of use in the modern professional machine shop.

CAUTION: Chips coming off the carbide inserts can be very HOT! Use extreme caution. Carbide inserts can also shatter. For these reasons, proper protective eyewear and clothing are especially important when using these tools.

Some materials like tool steel tend to build up a long, thin chip that wraps around the spinning part like steel wool. Use a chip brush or stop occasionally to remove this material often. Note that red hot chips can cause this “bird’s nest” clump of material to burn. Clean up often to keep the pile of chips to a minimum near the cutter.

Additional information

Weight 0.50 lbs
Dimensions 6 × 2 × 2 in

You may also like…