Description
White Ensign Models 1/350 Ticonderoga Class Cruisers Photoetch Enhancement Parts
White Ensign Models 1/350 Ticonderoga Class Cruisers Photoetch Enhancement Parts
The White Ensign models Photoetch add-ons makes your model ship museum quality.
This set contains:
- Railings main deck aft section
- Transom
- Main deck mid port railings
- Main deck mid starboard
- Side stern
- Hangar roof aft
- Port aft superstructure
- Hangar roof starboard
- Midship superstructure
- Fantail step
- Forward superstructure
- Aft intake vent
- Port and starboard ECM platforms and supports
- Forward port aft superstructure
- Port and starboard boat decks
- Mainmast deckhouse (early)
- Port and starboard bridge wings and bridge roof
- Small and large funnel uptake surrounds
- Starboard boat deck supports
- Inclined ladders for: lower
- Middle and top starboard boat deck
- Aft bridge starboard
- Mid superstructure aft
- Fantail step
- Flight deck aft
- Mid superstructure forward
- Early and late aft director platforms
- Railings and supports
- ECM/ESM platform bracings
- Late starboard boat deck platforms
- Forward funnel double antenna platform
- Forward funnel access platform
- Starboard boat deck platforms
General instructions:
- Do not remove the etched parts from the fret until you are ready to use them.
- Before assembly, soak the etched parts in a suitable solvent, such as white spirit, to de-grease the surfaces for painting.
- Cyanoacrylate adhesive (super glue) or contact adhesive such as Elmers white glue may be used. These can be applied with a pin or piece of stretched sprue.
- When removing parts from the fret, place the fret on a hard surface, such as a smooth ceramic tile, in order to prevent parts bending whilst cutting through the holding
tabs. We suggest using a #11 type of modelling knife blade for this purpose.
Accordingly, we suggest you purchase our Photoetch Bender Tools for easy assembly.
