Sherline 10 Inch CNC Ready Mill Package 5000A-CNC


Sherline 10 Inch CNC Ready Mill Package 5000A-CNC

SKU: sher-5000A-CNC Category: Tag:


Sherline 10 Inch CNC Ready Mill Package 5000A-CNC

10 Inch CNC Ready Mill Package

You can order any Sherline mill with stepper motor mounts factory installed in place of the handwheels and ready for the application of stepper motors and computer numeric controls (CNC). Sherline supplies the mounts, and several aftermarket suppliers offer motors, drivers, and software to complete the CNC system. You supply the 486 or better computer.

Sherline recommends using dual shaft stepper motors. This is for the application of handwheels to the rear shaft for manual control. With that in mind, handwheels for each axis come with the machine. although they cannot be used until stepper motors are installed. Sherline also offers high-quality stepper motors, which can be found in the accessories section of this site.

New Mill Features

  • Oil reservoirs on the X/Y axes and the Z-axis to help keep critical parts lubricated. These were initially developed for CNC machines that run constantly for hours on end but can benefit manual machines as well
  • Brass leadscrew cover that keeps chips off the rear of the Y-axis leadscrew

Standard equipment for the mill includes:

  • A powerful 90V DC motor with electronic speed controller
  • 10″ base
  • The handwheels are included and can be mounted to the end of the stepper motors to maintain manual control when needed.* 2-1/2″ (63mm) adjustable “zero” handwheel on the Z-axis and 2″ (51mm) adjustable “zero” handwheels on the X- and Y-axes. Each handwheel has laser engraved aluminum handwheel collars
    *NOTE: CNC-ready machines cannot be operated manually until stepper motors are installed.
  • 2.75″ (70 mm) x 13.0″ (330 mm) table with two T-slots
  • Pulleys, drive belt, three hexagonal keys, spindle bars, gib removal tool, eight-foot three-wire power cord, and instruction manual

10 Inch CNC Ready Mill Package Includes:

  • CNC Stepper Motor Mounts Installed
  • 1072 1/4″ Jacobs Drill Chuck
  • 3013 Step Block Hold-down Set
  • 3020 5/32″ Sherline Hex T-Driver
  • 3021 3 pc. Center Drill Set
  • 3052 Fly Cutter w/ Carbide bit
  • 3060 3-pc. Mill Collet Set w/ Drawbolt
  • 3079 3/8″ End Mill Holder
  • 3551 Milling vise
  • 5327 Sherline Accessories Shop Guide book
  • 7400 6-pc. 3/8″ Shank End Mill Set


Additional information

Weight 30 lbs
Dimensions 12 × 12 × 12 in

You may also like…