Sherline 1296 Cutoff Tool Holder Riser Block

$55.13

Sherline 1296 Cutoff Tool Holder Riser Block

Description

Sherline 1296 – Cutoff Tool Holder Riser Block

 NOTE: The riser block is shown in the photo with the P/N 3002 cutoff tool holder mounted on top to show how it works. The cutoff tool and holder are NOT included with the P/N 1296 riser block.

The cutoff tool is used to part off small stock less than an inch in diameter. The riser blocks are available so that stock up to 6″ in diameter can be turned. So if you can’t part off large material, why make a cutoff tool riser block available?

The answer is than many people prefer to leave their riser blocks in place at all times, even when turning small work, and they need a way to part off the work. The cutoff tool holder riser block goes under the P/N 3002 cutoff tool holder to allow it to be used with the riser blocks in place.

To increase rigidity and reduce “chatter”, the riser block is designed to be used on the “back” side of the work with the blade held upside down. This means the direction of rotation tends to lift the tool rather than push down on it, making for a smoother cut. It also has an extra wide base with two mounting screws to further increase strength.

Center high is 2.050″ high

Additional information

Weight 2 lbs